Why is my atomic clock not syncing?
Try powering down the clock (unplug it or remove the batteries), then turn it on again to see if it synchronizes. If the clock uses batteries, check them and replace if necessary. If the radio controlled clock is a desk top unit, try rotating it 90 degrees.
How do I get WWVB signal?
Place the clock along a wall or near a window that faces Fort Collins, Colorado. Locate the clock at least 1 or 2 meters away from any computer monitors, which can cause interference (some monitors have a scan frequency at or near the WWVB carrier frequency of 60 kHz).
Why has my radio-controlled clock stopped working?
Try rotating the clock. Most radio-controlled clocks have an internal antenna that picks up the signal most effectively when it is facing directly towards or away from Anthorn. Some clocks have a signal strength indication that helps in finding the best reception. Try moving your clock to a different location.
How do you reset the time zone on a sharp atomic clock?
- Press the “RESET” button on the back of the clock.
- Set the time zone by pressing and releasing the “TIME” button on the clock. Press the “UP” button to cycle through the four available United States’ time zones.
- Hold down the “TIME” button until the year setting begins to flash.
How do you set the DST on a sharp atomic clock?
3. DST ON/OFF SWITCH: Before insert the battery, select the DST mode. The clock has programmed to automatically switch when the daylight saving time is in effect. 4.
How do I set the time and date on my sharp atomic clock?
Time and Date To access the settings screen on the Sharp atomic clock, hold down the “Time” or “Month/Day” buttons for three seconds, then use the up and down arrows to increase or decrease the number values to the desired time or date.
Is Wwvb still transmitting?
Broadcast Outages for WWVB During normal operation, the 60 kHz signal from WWVB is transmitted 24 hours per day, 7 days a week.
How many batteries does the sharp atomic wall clock take?
Battery powered: Main unit 3 x AA batteries Sensor 2 x AA batteries (not included) The Sharp Atomic Wall Clock has a built in receiver that automatically synchronizes itself with the WWVB radio broadcast by the US Government ‘s National Institute of Standards and Technology (NIST) in Fort Collins, Colorado.
How does a radio controlled clock work with WWVB?
Once your radio controlled clock has decoded the signal from WWVB, it will synchronize its own clock to the message received by radio. Before it does so, it applies a time zone correction, based on the time zone setting that you supplied.
How does an atomic wall clock work?
Atomic Wall Clock Operating Instructions The radio controlled mechanism in your clock tunes itself to the time signal broadcast by the official U.S. Atomic Clock in Fort Collins, Colorado, also known as WWVB. The clock’s time setting will occur automatically soon after the battery is inserted.
What is the UPC for sharp atomic clock?
Sharp Atomic Clock – Weather Station UPC – 0049353998732 Atomic Accuracy: The Atomic clock has a built-in receiver that automatically synchronizes itself with the WWVB radio broadcast by the US Government’s National Institute (NIST) in Fort Collins, Colorado.