What is the easiest way to remove ball joints?
Place your jack directly underneath your axle hub where the ball joint goes down. You can put a piece of wood in between your axle hub and the jack. Then gently raise the hub a bit. Now you should be able to use a hammer to separate the bottom part of the joint from the top.
What tool is used to remove ball joints?
Use a socket wrench to remove the axle nut. Push the axle back through and loosen the knuckle assembly, moving it to gain access to the ball joint….Removing the ball joint.
| Set up ball joint separator tool. | Remove axle nut. |
|---|---|
| Fit upper adapter onto ball joint. | Fit lower adapter onto ball joint. |
How much does it cost to replace a ball joint on a Ram 1500?
The average cost for a Dodge Ram 1500 suspension ball joint replacement is between $285 and $361. Labor costs are estimated between $182 and $230 while parts are priced between $103 and $131.
What is a ball joint on a Dodge Ram?
This article applies to the Dodge Ram 2nd and 3rd generation (1994-2008). The ball joints in your Ram truck are designed to allow suspension and steering components move freely, and with reduced friction, wear and tear will occur.
How do you remove the ball joint on a Toyota Corolla?
Cap, pin, and center nut have been removed. Use the 13/16″ wrench to undo the nut located below the upper ball joint, and then proceed to apply a little pressure from below the control arm with the floor jack; this will make sure parts slowly come off in a safe manner. Then use the ball joint fork to pop the joint out.
How do you remove a ball joint from a floor jack?
Use the 13/16″ wrench to undo the nut located below the upper ball joint, and then proceed to apply a little pressure from below the control arm with the floor jack; this will make sure parts slowly come off in a safe manner. Then use the ball joint fork to pop the joint out. Figure 5. Undo the castle nut on the upper joint. Figure 6.
How do you remove the castle nut from a ball joint?
Start by using the needle nose pliers to pull the cotter pin out the lower joint castle nut, and then the 3/16″ wrench to remove the castle nut. Follow to use the ball joint fork to pop the old joint out of place, or use the ball joint press if it’s too tight.