Why is my SkyScan atomic clock not working?
If your outside temperature is not showing on your clock, that may mean that the clock and the transmitter have lost their connection. To reconnect them you must first take the batteries out of both of the units for 15 minutes. First put the batteries back into the transmitter, and then the clock.
How does a SkyScan atomic clock work?
The SkyScan® Atomic Clock automatically sets itself to the correct time and date by receiving and decoding the NIST radio signal with an internal receiver. It ensures daily accuracy to the fraction of a second by refreshing the signal each day.
How do you reset the temperature on an outdoor atomic clock?
Once the sensor is reading to your clock, place it outside in a shaded location. Hold the SET button to enter the Settings Menu. Press the PLUS button to adjust values. Press the SET button to confirm and move to the next item or exit.
How do I reset my SkyScan atomic clock?
Press and release the “+” key until it’s at the right minute. Press and release the “SET” key to move to setting the “year”. Repeat this action to set the month, date, weekday, 12/24H time format, and temperature setting. Remember that if set properly, SkyScan clocks are able to set themselves.
How do you reset a SkyScan atomic clock?
How do I set the time zone on my skyscan atomic clock?
Select the time zone that you are in. The SkyScan atomic clock can only collect the correct signal from 2,000 miles (3,200 km) away, so it must be set to the correct zone to get an accurate reading. Press and hold one of the four time zone buttons MT-Mountain Time, CT-Central Time, ET-Eastern Time, and PT-Pacific Time.
How do you set an atomic wall clock?
Setting an atomic wall clock is simple. Insert the correct number of fresh AA LR6 alkaline batteries in the battery compartment according to the polarity markings. It’s best to do this late in the evening because longwave radio signals are normally not received during the day.
How does a radio controlled clock work with WWVB?
Once your radio controlled clock has decoded the signal from WWVB, it will synchronize its own clock to the message received by radio. Before it does so, it applies a time zone correction, based on the time zone setting that you supplied.
How to set a skyscan clock with a weather station transmitter?
Method 2 Setting a SkyScan Clock with a Weather Station Transmitter. Confirm the channel setting by pressing the “Reset” button. The “Reset” button is inside the battery compartment using a small pin. Slide the C/F switch inside of the compartment for centigrade or Fahrenheit. Replace and screw in the battery cover.