How do you drain water from a waterbed?

How do you drain water from a waterbed?

Follow these easy steps to drain your waterbed properly:

1. Unplug the heater before draining the waterbed for your safety.
2. Put a towel by the valve and burp all the air out of the mattress.
3. Burp out the air again!
4. Put the cap back on the mattress to keep air from going in.
5. Put the hose extension on the end of the hose.

How do you drain a waterbed bladder?

Turn off the water and disconnect the hose from the faucet. Drop the hose to the ground. As long as this end of the hose is lower than the waterbed, gravity will make sure that the water drains out. If the water is not flowing freely, you can try sucking the air out of the hose with your mouth.

How do you drain a fiber filled waterbed?

Turn the water on full blast, let the water reach the mattress. Once the water has reached the mattress, turn the water off and quickly disconnect the hose from the faucet and lay the hose down. In a moment the water should start backing out of the hose, pulling the water from the mattress behind it.

How do you drain a waterbed with a drain kit?

To drain a waterbed with a drain kit, attach the faucet adaptor to the sink, connect a hose to the outflow from the adapter, connect the mattress valve to the adapter and turn on the faucet. This will replace the water in the waterbed.

How do I drain a waterbed without a pump?

How to Drain a Waterbed Without a Pump

1. Undress the Bed. Remove the sheets and mattress cover from the bed and unplug the water heater.
2. Bring in a Garden Hose.
3. Attach the Garden Hose to the Waterbed Connector.
4. Open the Drain Plug and Attach the Hose.
5. Prop Up the Upper Portion of the Mattress.
6. Remove the Garden Hose.

How long does it take to drain waterbed?

– Without a pump to help move the water, it takes between one and two hours to drain a king-size waterbed.

How long does a waterbed take to drain?

With a pump, a king-size waterbed takes just under an hour to drain, usually around 50 minutes.

Take the hose extension through the window to the waterbed, open the valve and insert the extension into the mattress. Catch any spilled water with your towels. Disconnect the hose from the outside faucet and take it to the lowest spot in the yard it will reach. Relax — your drained waterbed will be vacuum-packed.

How long does it take to drain a waterbed without a pump?

How do you empty a water bed fast?

Here’s how to drain a waterbed without a pump.

1. Unplug the temperature control unit, if you waterbed has one.
2. Attach one end of a garden hose to a faucet outside the house and the other end to the waterbed’s drain valve.
3. Turn on the water for 15 seconds.
4. Turn off the water and disconnect the hose from the faucet.

How many gallons of water is in a waterbed?

Waterbed mattresses, depending on the size, hold about 80–235 US gal (300–890 L) of water, which could bring the weight of the entire bed to over 2,000 lb (910 kg).

Do you change the water in a waterbed?

Unless you are moving your water mattress, there is no need to change the water. However, you will need to continue to add waterbed conditioner once every year.