How do you set up Jaybird earbuds?
How Do I Pair My Jaybird Run Earbuds?
- Remove your earbuds from the charging case and put them in your ears.
- On your Bluetooth® device, go to Bluetooth settings, make sure Bluetooth is on, and select Jaybird RUN on the available devices list.
- Once connected, you will hear “Connected” on your right earbud.
Why is my Jaybird flashing red and green?
If the headset is already turned on in Standby mode, or connected to an audio device, you can get the headset into pairing mode by pressing and holding both volume buttons until you see the light on the headset begin to flash red and green, indicating pairing mode.
How do you put Jaybird headphones in pairing mode?
With your buds turned off, press and hold the Power Button until you see the LED flashing red/green. When the LED flashes red/green, the buds are ready to pair. A voice prompt will say “Searching for your music device”. Select “Jaybird X3” in the list of discovered devices to connect.
How do you reset jaybird earbuds?
To reset your buds, follow the steps below.
- Make sure your buds are powered off.
- From an off state, press and hold the power button for 8 seconds until the LEDs flash red and green.
- Double press the power button. The LED will flash rapidly and you should hear a double tone. Your buds have now been reset.
Why are my jaybirds not charging?
Visible or non-visible dirt or dust might cause your Jaybird RUN buds to not charge, turn on, or the charge case LEDs not working as described.
How do you turn on Jaybird earbuds?
Inserting your earbuds into the charging case will automatically turn them off and taking your Jaybird RUN earbuds out of the charging case will automatically turn them on. Or: Press the multifunction button on both earbuds for 3 seconds.
How do you reset Jaybird headphones?
How Do I Reset My Buds?
- Make sure your buds are powered off.
- From an off state, press and hold the power button for 8 seconds until the LEDs flash red and green.
- Double press the power button. The LED will flash rapidly and you should hear a double tone. Your buds have now been reset.
How do I know when my jaybirds are charged?
Take the included USB charging cradle and plug it into a USB power source. 2. The white LED will start pulsing when charging, and will turn solid white when fully charged. We recommend you charge your earbuds using any 5V 500mA USB power source.
How do I know when my jaybirds are fully charged?
The left and right LED’s on the charging case will indicate the charging status for about 10 seconds when the case is closed and not plugged into power.
- Green LED pulses = Charging.
- Green LED solid = Fully charged.