How do I set my router to client mode?

[edit] Client Mode Setup 2.1. Connect a cable from your computer to the LAN port on your router. Set a username and password – if not asked for this, do a proper reset! Go to Wireless: these settings must match the primary host router – Check spelling and case!

Table of Contents

What is Client mode?

In Client mode, the access point connects your wired devices to a wireless network. This mode is suitable when you have a wired device with an Ethernet port and no wireless capability, for example, a smart TV, Media Player, or game console and you want to connect it to the internet wirelessly. 1.

Can I use a TP link router as a wifi extender?

But what happens if your home is too large for a single Wi-Fi router to cover? If that’s the case, you can always get another TP-Link Wi-Fi router and use it as a repeater. That means you will get to extend the coverage of your primary router, so it covers the entire house.

How do I turn my tp link router into a repeater?

Connect the WR702N directly to your computer’s Ethernet port by an Ethernet cable;

Power on the WR702N.
Click OK to exit.
Open a Web Browser -> Type 192.168.0.254 in the address bar -> Press Enter.
Enter the default Password: admin.
Go to Quick Setup-> Click Next.
Select Repeater-> Click Next.
Click Survey.

How does client mode work?

A Client Mode router connects to a Wireless Access Point (WAP) wireless connection as the WAN interface, and shares the internet connection only to the LAN ports, or a separate WAP for multi-radio routers. It is not seen as a WAP, nor accepts wireless connections by other client devices.

What is client mode Wi-Fi extender?

With client mode, it can connect to a wired device and works as a wireless adapter to receive wireless signal from your wireless network. For a Smart TV, Media Player, or game console with an Ethernet port. Use the Client Mode to make your devices Wi-Fi enabled, granting them access to your wireless network.

How do I setup my TP-Link wireless router as a receiver?

TP-Link has an article on this :

Log into TP-LINK wireless router’s management page.
Go to Wireless -> Wireless Settings. Check Enable WDS (Enable WDS bridging).
Click Search/Survey. On the pop-up window, find the SSID and channel of your root AP, and hit Connect.
Click DHCP-> DHCP Settings page.

How do I setup my TP-Link wireless router as a repeater?