Do you put subfloor under shower pan?
After you have put down a double layer of plywood to provide the base for a custom walk-in shower pan, you need to cover the subfloor with a layer of tar paper, in this case referred to as a vapor barrier or a moisture barrier.
Do you fit shower tray before tiling?
We always advise fitting the shower tray before tiling the walls or installing wall panels as this ensures a more watertight seal around the sides of the tray.
Do you install shower pan before drywall?
For tile or shower panels, drywall goes in first. Installing a shower pan includes many steps, such as cementing the floor to create a sturdy base and installing the shower walls.
Can you install shower pan without mortar?
If you decide not to install a mortar bed alternatives include installing another layer of sub flooring, or cement backer board. Leveling compounds also take the place of mortar on strong sub floors that are not level. A level floor is important for proper drainage.
What do you stick a shower tray down with?
Using either tile adhesive, silicone or a weak cement mix (5 parts sand/ 1 part cement) apply sufficient to board to cover entire underside of tray. Apply a minimum of 5mm thickness to lowest point of tray.
Do you put cement board under shower base?
The cement board must be installed before the shower pan. If the shower pan is not correctly placed, it might lead to other complications in the future. Therefore, it is important the person in charge of the installation gets it right at once. The wallboard should be placed 1/8 inch over the shower pan.
Do you install cement board before shower pan?
This may result in the pan being screwed to the wallboard instead of the studs. This will create a small lip at the bottom of the shower walls where tiles or an acrylic surround would bump out, leaving a gap. Therefore, the pan must be installed first.
Do you install shower tray before tiling?
Do you screw shower base to wall?
Unlike concrete shower pans which bond to the floor and are held in place by cement, shower bases are held in place with screws. Connecting the shower base to the wall studs is part of the installation process to hold the pan in place.
How to install a sterling shower base?
Level
Do you need glue on installing a shower base?
When replacing a shower pan, some shower pan manufacturers call for the shower pan to sit directly in an adhesive or into small mounds of mortar. If adhesive is called for, spread it within the area where the shower pan will sit. If mounds of mortar are called for, mark the locations on the subfloor per the manufacturer’s instructions.
How to install a preformed shower base?
The entire bottom of the shower pan needs to sit on a flat,level surface.
How to install a shower base on concrete floor?
In order to allow space for the waste pipe,make sure that you remove enough space.